HACK WIFI using these commands

Hlw friends today am going to tell you that how can you crack the password of a wifi of security WPA



Step 1: Open Your Terminal And Type “Ifconfig ’’  And Press Enter to check your Interface status


Step 2:  Here I will be selecting wlan0 as my interface


  And the Next Command Is  “airmon-ng start wlan0”



You Should See Something Like This



Then you can see all the available supplicants and kill them By Using Kill Command


Note : there are 2 methods for going into the next step



1)   By Using Kill Command and Stopping the Wlan0 Supplicants



2)   By Using the Command "airodump-ng mon0" instead of kill and "airodump-ng wlan0" Here i am using Kill Command, Either way we can continue


Now Type The Following Command "airodump-ng wlan0"


Here you can see all the available wifi networks

Press “CTRL + C” To Stop The Search


Now Type “wash –i mono”


this command is used to see all the available wps enabled networks among the available networks



Here you will be shown all "wps" Enabled networks


Press “CTRL +C” To Stop The Search And Select The Network That You Want To Hack



Copy the bssid of the network that you want to hack


Now use The reaver Command

“reaver –i mon0 –b bssid -vv”


Here bssid = the mac address or the bssid  that you copied earlier


 mon0= Interface (you can use either wlan0 or mon0 account to the                                                interface that we started earlier)




Now what you have to do is just wait till it reaches 100%



After reaching 100% You can see the password of that network, as it takes a lot of time I am not able to show you the password of that network. But I will guarantee you that this is the best and easiest way to hack wifi wpa and wpa2 password


Now Almost all of  the routers come with WPS Turned ON.

This is the AP RATE LIMITING SECURITY SYSTEM



If you face this Error, most likely you should stop using this particular method and go for Evil Twin Method, Which can Hack any router but with user Interference. 


The Reason for getting this Error is  WPS Protection is turned "ON" on the victim's Router. We can not this kind of router's using Reaver


If you get an error of AP Rate Limiting then try using the following commands, for very few router's this command will work

“reaver –i mon0 –b bssid –d 30 –vv –dh-small”



If the same thing happens leave that network and opt for another one or  try hacking using another method, but do not stop unfinished work..